Top 10 things to check before buying a home.

ten

 

Buying a home can be overwhelming at the best of times and its easy to get carried away with the excitement of it all.  While its important to love the decor, positioning and layout of the home, there’s more to consider than just what you see on the inside.  Here’s a list of the Ten most important things to look at when buying a property.

 

1. Are there any water stains or corrosion to the walls backing onto the showers or baths?

Try to look at the walls backing onto these areas for any signs of moisture penetration or water leaks. This is not a structural defect but can be a costly maintenance item for repair.

2. Check the ceilings are not sagging

Look at the ceilings to see if they are fixed firmly flush into place and do not have a ‘parachute’ appearance. This can be easily done by shining a torch across the ceilings, as this will show up all deflections and defects in the ceiling sheets.

3. Check inside the cabinets in all the wet areas

All cabinets should be opened to detect if there is a smell of damp, mould and mildew. Any damp smells can be an indication of water leaks or even rising damp.

4. Check the walls for large cracks

The internal and external walls should be visually checked to note any large wall cracks. Cracks that are greater than 2.0mm in width or properties with excessive cracking can be cause for concern and should be further inspected by a qualified building inspector.

5. Is there any evidence of mould in the bathrooms or bedrooms?

Mould can just look like dirty clouds on the walls and ceilings, especially if they have been recently cleaned. Mould has to be cleaned by professional mould remediation companies and can be quite expensive to have removed. Plus there is the question of the initial cause of the mould, is it more than just bad upkeep?

6. Check the internal wall plastering for fine cracks

The internal wall plastering can be easily checked for fine hairline cracks (map cracking, as they take on the appearance of a map). These cracks are caused by the incorrect application of the wall plastering at the time of construction. Once these cracks are found in one area of the property you will usually find in in multiple or all areas. The cracking plaster can crack further and even come loose, especially when wall fixings for paintings are installed.

7. Check the roof lines from the external

Look up the lines of the roof from the external if possible to check if they are straight and free from deflections.

8. Check the roof gutters are not rusted on their inside edges

The roof gutters may look great from ground lever but if checked from their top side they may appear very corroded and soon require replacement.

9. Check the roof downpipes are running to storm water soak well drains

Do a quick walk around the external perimeter of the home to check that all roof downpipes are discharging into stormwater soak wells and not just discharging onto the ground. You should also look for any signs of past flooding or excess water flow around the roof downpipe bases as this can be an indication that the soak wells are not suitably sized or require cleaning out, which can be a costly maintenance item. To install stormwater soak wells on an established property can be very expensive, as paving, concrete and garden beds may need to be excavated to install the drains.

10. Are there drain holes present on the external perimeter walls of the home?

This item is important for multistory properties. There should be small holes evident above and below window and door frames and along the suspended slab levels. The holes will usually be spaced approximately 1200mm apart. These holes allow water to escape from the cavity walls. Without these holes water can penetrate the internal walls of the home caused ongoing and expensive maintenance.

Find out more at real-estate.com

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes:

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>